Which red dots you can mount using the CZ plate for Trijicon RMR? In this article we will show all red dots compatible with the Trijicon RMR footprint standard.
Compatible red dots
Trijicon RMR is one of the most common footprint patterns used for red dots. Just because a red dot uses some footprint pattern does not necessarily mean it will fit the gun.
In this compatibility list we will go through
- a) red dots compatible with Trijicon RMR footprint, and
- b) red dots compatible with CZ P-10C optics ready – meaning the dimensions would match the cut in the slide.
ADE Advanced Optics
For ADE Advanced Optics the following red dot models use Trijicon RMR footprint and are fitting into the slide cut of optics ready CZ P10C.
- ADE Advanced Optics RD3-019 Stingray
- ADE Advanced Optics RD3-020 Raptor
- ADE Advanced Optics RD3-023 Valkyrie
- RD3-029 Pro Trumpet
- RD3-022 Artemis Pro
Holosun
Following Holosun red dots use Trijicon RMR footprint and are fitting into the slide cut of optics ready CZ P10C.
- Holosun 407C
- Holosun 407C X2
- Holosun 507C
- Holosun 507C X2
- Holosun 507COMP
- Holosun 508T
- Holosun 508T X2
Note that Holosun 407K models and Holosun 507K models use different footprint from models 407C and 507C.
Swampfox
For Swampfox these red dots use Trijicon RMR footprint and are fitting into the slide cut of optics ready CZ P10C.
- Swampfox Justice RMR 1×27
- Swampfox Liberty RMR 1×22
- Swampox Kingslayer
Trijicon
All versions of Trijicon RMR and Trijicon SRO red dots will fit the CZ P10C OR pistol with Trijicon RMR footprint.
- Trijicon RMR
- Trijicon SRO
Vector Optics
From Vector Optics only the following red dot will be fitting Trijicon RMR plate for CZ P10C optics ready.
- Vector Optics Frenzy 1x22x26
Installation of plate to CZ P-10C optics ready
In order to accomodate any of the above listed red dots to your CZ P10C optics ready, you will need to have a Trijicon RMR red dot plate for P-10C OR.
Installation of the plate is simple and can be done with basic tools from home. See full installation guide here.
You will need only T10 hex key, locktide and thats it.
For the screws that come together with the plate its recommended to use max torque 1.3 Nm.